WORK SHEET
Task: Install a urinal.

TOOLS/EQUIPMENT: Monkey wrench, plumber’s wrench, slit socket spanner, Star screw

                 driver, open wrench 11, T.Z 15 N special wrench.

MATERIALS: Sealing tape, water and waste cloth.
step one 

1. Prepare for fitting.
   
2. Attach the flange
   
3. Attach a seal gasket/rubber packing outlet of the urinal and attach the urinal. Tighten the screws.
4. Install the spud
5. Insert the spud through the wash bowl inlet
6. Put on the skirt parking
7. Pull the body forward, insert the spring washer and tighten the nut.
8. 
   
   
9. 
   
   
10. 
    Install the flush valve.
11. • Wind sealing tape on the screw end
    • Tighten the valve in by hand and securely by wrench.
     Note: Wind waste cloth around the valve to prevent it from getting scratches when tightening by wrench.
12. 
    
    
13. 
    
    
14. 
15. Install the flush pipe.
16. Insert the items below as in the  order:
    • Asbestos/steel packing
    • Two nuts in opposite direction, one to fix to the flush pipe to the flush valve and the other to the spud.
    • Spring washer
    • Rubber washer
    • 
      
    
      
17. Tighten the nuts by hand and finally using wrench. Remember not to over tighten as this action will crash the urinal.
18. 
    
    
19. 
    
    
20.                                                                                                                                                                                        wow! that is the project. well done proceed and open the water supply and test for leakagesif no leakage is found then you earned it you become a proffessional. good luck          enjoy plumbing.prepared by Gilbert Niwamanya- instructor Uganda.